Contact RICHLINCO
40 Allen Boulevard
Farmingdale, NY 11735
Tel: (631) 694-9400
info@richlinco.com

Checking the height of center of a tooling plate

 

Checking the height of center of a tooling plate

 

Following these steps to check the height of center of a tooling plate:1. Sweep across the top of a pin in the spindle.
Checking the height of center of a tooling plate
2.Use gauge blocks to find the height.If you used a 1/2″ pin with a slide that has 1/2″ center, you should find the top of pin at .7500″.
Be sure to measure the pin accurately and check that it runs concentric with the spindle. If the pin is off, your height of center will be, as well.

If the gauge blocks find zero at .752″ then you know your slide is .002″ too low.

Checking the height of center of a tooling plate

 

© 2018 Richlin Machinery Inc. Richlin Machinery, Inc. Click here for directions
40 Allen Blvd. Farmingdale, New York 11735
Tel: (631) 694-9400 | Fax: (631) 694-9415 | info@richlinco.com